您好,欢迎光临济南金力升降机械有限公司官方网站!
24小时服务热线:18766191320

24小时服务热线

18766191320

剪叉式升降机对电机的要求是什么样的?

来源:http://www.jlsjj.cn     发布时间:2022-04-25   浏览次数:

剪叉式升降机的运行过程中,发生故障或者停电,可以使用应急使用,主要有以下几种。
In case of failure or power failure during the operation of scissor lift, it can be used for emergency use, mainly including the following.
1、应急手动阀:可以在停电时打开,会缓慢下降的低层的位置。
1. Emergency manual valve: it can be opened in case of power failure and will descend slowly.
2、手动泵:当无法供电或者动力不足时,可以使用手动泵来提供动力使广西剪叉式升降机上升,不过对于高度较高的型号,我们不建议使用此类模式,应为它的效率比较低,费时费力。
2. Manual pump: when the power supply is unavailable or the power is insufficient, the manual pump can be used to provide power to raise the scissor lift in Guangxi. However, for the models with high height, we do not recommend using this mode, because its efficiency is relatively low and time-consuming.
3、破裂保护阀:当液压管路破裂,导致压力骤降时,可以自动切断回油,防止台面坠落,有较好的性。
3. Rupture protection valve: when the hydraulic pipeline breaks, resulting in a sudden drop in pressure, it can automatically cut off the oil return to prevent the table from falling, which has good safety.
4、液压油温保护:当油箱中的液压油温度过高时会发出警示音,此时我们建议停止使用,待降温后方可继续使用。
4. Hydraulic oil temperature protection: when the hydraulic oil temperature in the oil tank is too high, a warning sound will be sent out. At this time, we suggest to stop using it and continue to use it after cooling down.
绿色理念是剪叉式升降机发展总趋势。发展趋势主要有如下:不断改进产品的设计、生产环保型低能耗、低噪声、无漏油、无漏水、无电磁干扰、无井道导轨油渍污染的剪叉式升降机。剪叉式升降机曳引采用尼龙合成纤维曳引绳、钢皮带等无润滑油污染曳引方式。
Green concept is the general development trend of scissor lift. The main development trends are as follows: continuously improve the design of products, and produce environment-friendly scissor lift with low energy consumption, low noise, no oil leakage, no water leakage, no electromagnetic interference and no oil pollution of hoistway guide rail. The traction of scissor lift adopts nylon synthetic fiber traction rope, steel belt and other traction methods without lubricating oil pollution.
对于剪叉式升降机电机的一些要求:
Some requirements for scissor lift motor:
1.良好的散热性能,因剪叉式升降机连续工作,需要强制通风
1. Good heat dissipation performance. Forced ventilation is required because the scissor lift works continuously
2.如采用直流电机,应有透明窗口,以方便检查碳刷和整流子。
2. If DC motor is adopted, there shall be transparent window to facilitate the inspection of carbon brush and commutator.
3.正对湿度大的场所,内部配加热器,配有过热报警和断电保护装置
3. Facing the place with high humidity, it is equipped with heater, overheating alarm and power-off protection device
4.对于在高温环境下作业的,应选用f级别绝缘
4. For those working in high temperature environment, class F insulation shall be selected
5.在室内安装剪叉式升降机,其电机保护等级不低于IP23,在室外应达到IP54
5. The scissors lift shall be installed indoors, and its motor protection grade shall not be lower than IP23, and shall reach IP54 outdoors
6.所有电机应在短时间内具有规定力矩过载能力
6. All motors shall have the specified torque overload capacity in a short time
7.风机在电机不用时,应有一可调的延时及断电功能,液压升降平台尤其如此。
7. The fan shall have an adjustable delay and power-off function when the motor is not in use, especially for the hydraulic lifting platform.
剪叉式升降机装璜将采用无环境污染材料、剪叉式升降机空载上升和满载下行电机发电回收技术,安装剪叉式升降机将无需安装脚手架,剪叉式升降机零件在生产和使用过程中对环境没有影响并且材料是可以回收的。
The decoration of the scissor lift will adopt the non polluting materials, the no-load lifting and full load descending motor power generation recovery technology of the scissor lift. The installation of the scissor lift will not need to install the scaffold. The parts of the scissor lift have no impact on the environment in the process of production and use, and the materials can be recycled.
以上就是为大家介绍的有关山东升降设备的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.jlsjj.cn
The above is the detailed introduction of the lifting equipment in Shandong Province. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.jlsjj.cn

上一篇:升降平台系统干扰问题升降机日常维护方法
下一篇:购买铝合金升降平台有哪些注意的